Beko CDA 664 F Instrukcja Naprawy Pobierz pdf (Strona 25)

Instruction & Technical Manual | 25

10. Start up

10.1 Procedure

1. Close valves A, B, C and D.

2. Switch on compressor.

3. Open valve A slowly.

4. Check there are no leaks from the

dryer.

5. Switch on electric power. All four

display panel LED’s will flash

simultaneously green four times

then simultaneously red four times

to acknowledge application of power

and readiness to function. Observe display panel for one complete cycle. Note: cycle

described is factory setting.

(i) Power LED illuminates green and tower LED X illuminates green.

(ii) After 120 seconds, tower LED X switches off and drain LED Z illuminates green.

(iii) After a further 50 seconds drain LED Z switches off and tower LED Y illuminates

green.

(iv) After a further 120 seconds, tower LED Y switches off

(v) After a further 50 seconds, tower LED X illuminates green - this is (i) in the cycle

described above.

(vi) The above cycle (i-iv) repeats.

(vii) Run the dryer for a minimum of 6 hours to ensure dewpoint is adequate.

(viii) Open valve B slowly.

POWER

Figure 7.2. Dryer in operation

Figure 7.3. Display panel

NB: Filters not supplied with dryer

POWER

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 39 40

Brak uwag

Beko CDA 664 F Instrukcja Naprawy Strona 25